Mercedes 230SL Tail Light Parts
Showing 5 out of 5 part(s) found in our catalog.
Brand
Keyword
Category
Select category below to view parts.
Mon-Fri 8-4 MST/PST (Arizona Time)
The average cost of a Mercedes 230SL tail light is between $1.19 and $36.99.
How Do I Replace A Mercedes 230SL Tail Light Bulb?
If your Mercedes 230SL tail light bulb goes out, changing it is pretty straightforward. Pop open your trunk to access the back of the light assembly, then locate the cover over the bulbs. Remove this panel to get to the sockets. Carefully twist the bulb holder counterclockwise to release it. Gently pull out the old bulb, pop the new one in, and make sure it’s firmly seated. Reverse the process to put everything back together, then check that your Mercedes 230SL tail light lights up properly before closing the trunk. Take your time—these parts are aging, and a gentle approach goes a long way.
Why Are My Mercedes 230SL Tail Lights Not Working?
If you’re dealing with a Mercedes 230SL tail light that isn’t working, a few common culprits could be behind it. Burned-out bulbs and blown fuses are obvious places to start. Moisture can sneak into the assembly, leading to corroded sockets or bad connections. Be sure to inspect the fuse box (look under the dash) and replace any blown fuses you spot. Also, check for any signs of rust, loose connections, or frayed wires in the Mercedes 230SL tail light setup. If you’ve checked all that and still have no luck, the issue might be deeper in the wiring or switch. Work through each step, and you’ll usually track down the problem.
How Do I Remove The Mercedes 230SL Tail Light Assembly?
Wondering how to take out the Mercedes 230SL tail light assembly? First, open the trunk and find the nuts or fasteners on the inside by the tail panel. Loosen these while holding the assembly from outside, just in case it’s ready to come loose. Carefully wiggle the assembly free, making sure not to scratch the paint or tear the gasket. Unplug the wiring harness to fully separate the unit. Before you reinstall anything, double-check the opening and the gasket for any signs of age or damage. Take it slow—these classic lenses and housings can be fragile and expensive to replace if cracked.
What Is The Correct Bulb Type For The Mercedes 230SL Tail Light?
Not sure which bulb your Mercedes 230SL tail light needs? Most classic models use a dual-filament bulb for both the stop and tail functions—usually an 1157 if you’re in the U.S. To be safe, pop out the old bulb and match it up with the new one, or check the car’s manual for exact specs. Using the right bulb keeps everything working smoothly and preserves the vintage look and proper brightness of your Mercedes 230SL tail light.
How Do I Stop Water Leaks Into The Mercedes 230SL Tail Light?
Noticed condensation or water inside your Mercedes 230SL tail light? This is often down to a hardened gasket, cracks in the lens, or loose screws. Take out the assembly, peel off the rubber gasket, and replace it if it looks brittle or worn. Clean all the mating surfaces before you put a new gasket in place. If you see any cracks in the lens, either seal it up with a small bead of waterproof sealant or look for a replacement lens. When you reinstall everything, tighten the mounting nuts evenly so there’s a good seal. Routine checks help catch leaks early and keep everything dry and shining.
Looking For A Mercedes 230SL Tail Light?
If you need a new Mercedes 230SL tail light, AutohausAZ has you covered. The process is easy—just check out their selection, pick what you need, and your order’s on its way in no time. Prices are fair, shipping is quick, and if it doesn’t fit, their return policy is hassle-free. That way, you get your classic back on the road fast and don’t overpay.
