Mercedes C280 Knock Sensor Parts
Showing 2 out of 2 part(s) found in our catalog.
Brand
Keyword
Subcategory
Mon-Fri 8-4 MST/PST (Arizona Time)
Mercedes C280 knock sensor typically cost between $14.69 and $20.79.
What Does The Mercedes C280 Knock Sensor Do?
The Mercedes C280 knock sensor sits on your engine, quietly handling an important job you might never think about. It’s built to pick up sounds and vibrations from the engine—especially the sharp “ping” that comes when things aren’t running right. If you get knock, the sensor spots it and signals the car’s computer. The system fixes the timing, tweaks the mix of air and fuel, and helps settle the engine down. All this work keeps your engine running smooth and steady, not wasting gas or rattling itself apart. If the knock sensor gives out, the engine starts to lose its edge. Power slips, the ride gets rough, and you can end up with bigger problems in the long run.
What Are The Symptoms Of A Faulty Mercedes C280 Knock Sensor?
When the Mercedes C280 knock sensor starts to fail, your car won’t keep quiet about it. Maybe the check engine light shows up, or you press the gas and it just doesn’t pick up like it used to. Sometimes you’ll hear a knock—a hard tap—from under the hood, usually when you accelerate. Other times, you notice the car running rough, using more fuel than normal, or just feeling sluggish. The car’s computer tries to handle things, but with bad info from the sensor, it can’t quite get it right. Waiting too long to check it out or swap out the sensor can lead to bigger headaches for your Mercedes C280.
Where Is The Mercedes C280 Knock Sensor Located?
The Mercedes C280 knock sensor is tucked away on the engine block. Most of the time, you’ll find it under the intake manifold, out of easy reach. Depending on your engine, there might be one or even two sensors, often sitting between the banks of cylinders. It’s not the simplest thing to get to. Usually, you’ll need to remove engine covers or the intake manifold for a clear shot at the sensor. Putting it all back together calls for careful hands and the right torque settings, so the sensor works as it should once you’re done.
How Do You Replace A Mercedes C280 Knock Sensor?
To swap out the Mercedes C280 knock sensor, you’ll want to disconnect the battery before anything else. Next, you take off the engine covers and often the intake manifold. After unplugging the sensor wiring, the old knock sensor can be unscrewed from the engine block. Line up the new sensor just right, tighten it to spec, then reconnect the wiring. Assembly goes in reverse. Make sure you clear the engine codes with a scan tool before firing up. It’s not a job for total beginners. You’ll want the right tools—and maybe an experienced friend at your side if you haven’t done it before.
How Much Does It Cost To Replace A Mercedes C280 Knock Sensor?
Replacing a Mercedes C280 knock sensor isn’t cheap, but it’s not the priciest job out there. For the part itself, expect to pay anywhere from $50 to $150, depending on the brand. Labor tends to cost more than the part, clocking in at $300 to $600 thanks to the teardown needed to reach the sensor. All told, most drivers spend between $350 and $750 for parts and labor. It’s money well spent if it helps save your engine from lasting damage or a drop in power.
Why Choose AutohausAZ For Your Mercedes C280 Knock Sensor?
Buying your Mercedes C280 knock sensor from AutohausAZ is about more than just getting a good deal on a part. You order from us, you get fast shipping, real support, and prices that make sense. Shipping goes out quickly, and if you pick the wrong part by mistake, sending it back is low-stress and fast. No runaround, no hidden fees. Our team is here if you need help figuring out the right sensor or have issues with an order. At the end of the day, fixing your Mercedes shouldn’t leave you frustrated. We just want to help you get to the finish line—with your C280 running strong and your wallet feeling okay too.
