Mercedes CL63 Idle Control Valve Parts

Showing 2 out of 2 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes CL63 Idle Control Valve
Category
Select category below to view parts.
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
2008, 2009, 2010 Mercedes CL63 AMG
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$38.99
Reg
$40.61
List
$61.00
1 per car.
2008, 2009, 2010 Mercedes CL63 AMG
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$34.99
Reg
$36.45
List
$61.00

The average cost of a Mercedes CL63 idle control valve is between $34.99 and $38.99.

What Are Common Signs Of A Faulty Mercedes CL63 Idle Control Valve?

When the Mercedes CL63 idle control valve starts acting up, you'll probably run into a handful of frustrating symptoms. Some drivers notice the idle gets rough, with the engine almost shaking at a stoplight. Sometimes the car even stalls out when you come to a stop. Unsteady or wandering idle speed crops up, too. A few people see their engine RPM shoot up high or dip low out of nowhere, even if they aren't touching the gas. In other cases, you turn the key and the car struggles to start or feels like it's about to die seconds after it catches. Most often, these problems tie back to how the engine breathes at idle—since the idle control valve handles air flow when your foot isn’t on the accelerator.

How Is The Mercedes CL63 Idle Control Valve Tested?

If you want to check the Mercedes CL63 idle control valve, you start by taking a look at the electrical connector—make sure it's not loose or corroded. Pop the hood, switch on the ignition, and listen close. A faint clicking sound is good news—it means the valve is reacting. Mechanics will often break out a scan tool to hunt for any stored engine codes about idle or air intake. Another trick is to unplug the valve with the engine running. If nothing happens when you disconnect it, the valve might be the problem. These checks save time and help you avoid wasting money on other parts.

Can The Idle Control Valve Be Cleaned Or Must It Be Replaced?

Sometimes, a grimy or sticky Mercedes CL63 idle control valve just needs a good cleaning. Tackle it with some throttle body cleaner, scrub away any built-up gunk or carbon, and see if your symptoms clear up. If the engine runs better for a while and then the problem returns, or if the valve isn't responding even after cleaning, it probably needs to be replaced. It doesn’t hurt to try cleaning first—sometimes that’s all it takes to get a smoother idle and avoid the cost of swapping out the whole part.

How Difficult Is It To Replace The Mercedes CL63 Idle Control Valve?

Swapping out the Mercedes CL63 idle control valve usually falls within reach of a patient DIYer. First, make sure the engine is cool. Most of the time, you loosen a few screws and unplug the connector, then lift out the old valve. Depending on where it sits in the engine bay, you might have to move a cover or a hose out of the way. Basic tools are enough, but working in tight spaces can test your patience. Once the new valve is in place, let the car run a bit while the computer settles in to the new part—sometimes a quick drive is all it takes for things to adjust.

What Causes The Mercedes CL63 Idle Control Valve To Fail?

The Mercedes CL63 idle control valve usually fails after years of exposure to oil vapor and heat. Sometimes carbon and dirt sneak past the air filter or up through worn seals, then pile up inside the valve and gum up the works. Old age can cause electrical contacts to wear out or corrode, too. In rare cases, splashes of water or cycles of freezing and thawing add to the damage. The best way to fend off an early failure? Change your air filter on time, keep an eye out for oil leaks, and stick to regular engine checkups.

Why Buy Your Mercedes CL63 Idle Control Valve From AutohausAZ?

Picking up your Mercedes CL63 idle control valve at AutohausAZ means less hassle and more confidence. You don’t pay the eye-watering price the dealer wants. We keep parts in stock and ship fast, so you spend less time with your car sitting in the garage. Our catalog makes finding the exact fit simple. If anything isn’t spot-on, send it back without a fight—returns are easy. We lean on years of experience and stock only trusted brands. Whether you’re wrenching on your own ride for the first time or you know the CL63 inside-out, we’re here to keep things straightforward. Quality, fair pricing, and helpful support. You need it, we’ve got it.