Mercedes CLK350 Mass Air Flow Sensor Parts

Showing 1 out of 1 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes CLK350
Category
Emission Control
Subcategory
Mass Air Flow Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
This unit is the original Bosch MAF mass airflow sensor, please verify MB 2730940948 or 68011734AA or Bosch part number on existing part prior to ordering. Proper installation may include possible reflashing...
2006, 2007, 2008, 2009 Mercedes CLK350
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$87.99
Reg
$91.66
List
$456.00

Based on industry averages you can expect to pay between $87.99 and $87.99 for a Mercedes CLK350 mass air flow sensor.

What Are Signs Of A Failing Mercedes CLK350 Mass Air Flow Sensor?

When the Mercedes CLK350 mass air flow sensor starts to go bad, it can feel like your whole car’s attitude changes. It might idle rough, hesitate or stutter when you press the gas, and sometimes even stall in the middle of traffic. The check engine light comes on and stays there, almost taunting you. Gas mileage can drop, and it may seem like you’re fueling up more than usual. Sometimes, the exhaust smells off, or you might see smoke, which hints the engine isn’t getting the mix just right. The drive becomes unpredictable—sometimes fine, sometimes anything but. If any of this sounds familiar, it’s smart to have a tech check it out, since other problems can also mimic these same issues. Cleaning or swapping in a new Mercedes CLK350 mass air flow sensor often gets things back to normal if the sensor is the culprit.

How Do You Clean The Mercedes CLK350 Mass Air Flow Sensor?

Cleaning the Mercedes CLK350 mass air flow sensor doesn’t call for much beyond some patience and the right spray. Pop the hood and look for the sensor, which sits after the air filter but before the engine’s throttle. Make sure the engine and battery are off, then slip the sensor out with care—those wires and parts inside won’t take much to break. Using a can of mass air flow sensor cleaner, give the threads and the sensor’s guts a few short sprays. Don’t poke or scrub anything; let the cleaner do its job. After about fifteen minutes of air drying, slide the sensor back in, reconnect any plugs or hoses, and fire up the car. Sometimes, a light clean is all it takes to stop weird running problems from popping up. Give it a little time and see if things smooth out.

What Happens If The Mercedes CLK350 Mass Air Flow Sensor Is Unplugged?

Pulling the plug on your Mercedes CLK350 mass air flow sensor doesn’t kill the engine, but it never helps things either. The car tries to manage with default settings. It often runs rough, sometimes with a delay between your foot and the engine’s response. That check engine light lights up, and if you plug in a code reader, you’ll find trouble codes saved. This move can help you figure out if the sensor is bad, but it’s not a fix. If you drive this way, expect worse performance, higher emissions, and stress on other parts. Swapping out a bad Mercedes CLK350 mass air flow sensor is the only way to get things running strong again.

How Do You Replace The Mercedes CLK350 Mass Air Flow Sensor?

Swapping the Mercedes CLK350 mass air flow sensor doesn’t take a mechanic—just some basic tools and a steady hand. First, shut off the car and disconnect the battery. You’ll see the sensor sitting on the intake tube between the air box and throttle. Clip off any wires, loosen the clamps, and slide out the old sensor. The new one goes right where the old one sat—tighten everything down and reconnect the wires. Check for loose hoses or clamps that could let in unfiltered air. Hook the battery back up, clear any codes with a scanner, and take the car for a spin. If the sensor was the problem, you’ll notice faster starts, better throttle response, and smoother overall running. Handle the new sensor with care; the sensing bits are easy to break.

Does The Mercedes CLK350 Mass Air Flow Sensor Need Coding Or Calibration?

Usually, you can drop in a new Mercedes CLK350 mass air flow sensor without worrying about coding or special setup. The engine computer is smart enough to learn the new sensor’s readings on its own, especially after you clear the codes and drive for a while. Give the car a few miles to adjust. Sometimes, problems linger if another issue is hiding, or if there’s a mismatch in sensor quality. Sticking to factory or top-shelf sensors avoids headaches. If warning lights stay on or the engine acts up even after replacement, don’t just keep driving—get the problem checked out. Sometimes, it takes a shop’s tools and know-how to make sure everything is right.

Why Buy Your Mercedes CLK350 Mass Air Flow Sensor From AutohausAZ?

We know how important it is to keep your Mercedes CLK350 running at its best, and when it comes to parts like the mass air flow sensor, you don’t want to gamble. That’s why we keep our inventory strong, our prices low, and our shipping lines moving quick. When you order from AutohausAZ, you skip the steep markups and confusing lists you might find at the big-box stores. Orders ship fast, so you’re not stranded in the garage, waiting days for a simple fix. If the part doesn’t fit, our return process is quick—no headaches, no resistance. We’re picky about what we stock, taking pride in only offering parts we’d trust in our own cars. Customers keep coming back and leaving those five-star reviews, which speaks louder than any ad could. If you hit a snag, a real person here will help get it sorted. When you need a Mercedes CLK350 mass air flow sensor, shop with us for honest prices, fast delivery, and a support team that knows cars as well as the catalogs.