Mercedes CLS500 Camshaft Position Sensor Parts

Showing 3 out of 3 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes CLS500
Category
Ignition
Subcategory
Camshaft Position/Reference Mark Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
2006 Mercedes CLS500
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$38.99
Reg
$40.61
List
$220.00
OEM
2006 Mercedes CLS500
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$29.99
Reg
$31.24
List
$222.00
OEM
2006 Mercedes CLS500
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$4.89
Reg
$5.09
List
$1.90

The average price of a Mercedes CLS500 camshaft position sensor is between $4.89 and $38.99.

What Are The Main Symptoms Of A Faulty Mercedes CLS500 Camshaft Position Sensor?

When the Mercedes CLS500 camshaft position sensor goes bad, things often feel off right away. The engine may idle rough like it wants to quit, or struggle to start at all. A glowing check engine light appears more often than not. Some drivers notice the car hesitates or bucks when accelerating. Others see a drop in fuel efficiency or even a full stall at a stoplight. Sometimes, the engine misfires once it's warm or loses power, as if it’s tired and can’t keep up. Occasionally, the car drops into limp mode, mostly as a way to stop more damage. Run a scan and a camshaft position sensor code usually pops up, telling you exactly where to begin looking.

Where Is The Mercedes CLS500 Camshaft Position Sensor Located?

Finding the Mercedes CLS500 camshaft position sensor means getting a bit hands-on. You’ll find it tucked near the front or back of the cylinder head, depending on your engine model. After popping the hood and taking off the engine’s plastic covers, the sensor comes into sight. It’s a small piece, held down by a couple of bolts, with a wire plugged into it. It can get lost among hoses and wires, so take your time to pick out the right one—especially since other sensors could be close by. You don't want to pull the wrong plug.

How Can I Replace The Mercedes CLS500 Camshaft Position Sensor?

Replacing the Mercedes CLS500 camshaft position sensor doesn’t ask much from you beyond a bit of patience and a few tools. Start with the battery—disconnect it so there’s no risk of shock. Once the sensor is in reach, unplug the connector, remove the bolts, and slip out the old sensor. Compare old and new, just to double-check. Slide in the new piece, secure the bolts, click the connector back in place. A snug fit matters. Clear the old codes out—use a scan tool—when you’re finished. A quick drive afterward can reassure you that everything is working like it should.

What Causes The Mercedes CLS500 Camshaft Position Sensor To Fail?

The Mercedes CLS500 camshaft position sensor doesn’t often fail out of nowhere. It usually gives up after plenty of engine heat, old wiring, or contact with leaking oil. Inside, the electronics or magnets inside just wear down over time, especially if they’re exposed to contaminants in the oil. Bad wiring, cracked connectors, or water getting in under the hood can also foul up the sensor. Sometimes, the real trouble comes back to an oil leak that goes ignored long enough to soak the sensor and kill it for good. With regular checks and prompt oil leak repairs, you can usually avoid early failures.

Do I Need To Reset Anything After Replacing The Camshaft Position Sensor?

After swapping in a new Mercedes CLS500 camshaft position sensor, you’ll want to clear out any codes with a scan tool. For most, the computer in the car figures out what’s happened and makes adjustments right on its own. Still, sometimes the check engine light stays on or the engine still acts up until the codes are erased properly. Most drivers notice things go back to normal after a quick reset. If that light is still there, give it another scan, or take a short drive—sometimes it just needs a little time to adjust.

Looking For An Affordable Mercedes CLS500 Camshaft Position Sensor?

At AutohausAZ, we know you want to keep your Mercedes CLS500 running smooth, without draining your wallet or wasting time. That's why we keep prices low and shipping fast. Need a camshaft position sensor? We've got you covered. Our site is made for quick, easy shopping, and our team is ready if you have questions. Not happy with your part? No problem—returns are simple and you won’t get stuck with extra fees. Hundreds trust us because we care about getting you back on the road, hassle-free. Saving money and getting real support—it's what we do every day at AutohausAZ.