Mercedes CLS55 ABS Relay Parts
Showing 4 out of 4 part(s) found in our catalog.
Brand
Keyword
Subcategory
Mon-Fri 8-4 MST/PST (Arizona Time)
The average cost of a Mercedes CLS55 abs relay is between $5.09 and $15.19.
Where Is The Mercedes CLS55 ABS Relay Located?
For the Mercedes CLS55 ABS relay, you’ll usually find it inside the fuse and relay box under the hood, most often on the passenger side near the windshield. Some CLS55s have small differences, so the box might not look exactly the same on every model year. You might have to pop off a cover or move a plastic shield to reach the relays. The fuse box lid typically has a diagram on the underside—scan for “ABS” or a relay symbol to guide you. Don’t forget to disconnect the battery before poking around. If things still seem confusing, check your owner’s manual for the most accurate info on your exact car.
What Are The Symptoms Of A Bad Mercedes CLS55 ABS Relay?
A broken Mercedes CLS55 ABS relay brings a few clear signs. The ABS warning light stays lit on the dash most of the time; that’s usually the first thing most notice. Sometimes, you’ll find the ABS just doesn’t kick in, even if you hit the brakes hard on a slick road. Other drivers mention buzzing or chatter from the ABS area, or they get a relay that works off and on—functioning fine one week, acting up the next. If any of this crops up, there’s a good chance the relay’s at fault. Putting this off means you lose a big piece of your car’s safety net, especially in a panic stop.
How Can I Test The Mercedes CLS55 ABS Relay?
Testing a Mercedes CLS55 ABS relay starts with the basics. Pull the relay and give it a once-over for any sign of burned marks or green-blue corrosion on the pins. Use a multimeter set to continuity, and check the pins—consult a diagram so you’re on the right ones. Some just swap the suspect relay with another of the same type from the fuse box. If things start working again, you’ve found the problem. Take care to disconnect the battery and pay attention to how you handle the connectors, especially if you’re near other relays or modules.
What Causes The Mercedes CLS55 ABS Relay To Fail?
A few things can take out the Mercedes CLS55 ABS relay. Years of flipping on and off wear on the relay’s tiny inside parts. Heat from the motor or water leaks can corrode or cook these pieces, knocking them out of action. Sometimes electrical shorts or a jolt from jump-starting the car can fry the contacts—this happens more than you’d think. Watch for crisp, white corrosion around the relay base during oil changes, and swap an older relay before it stops working for good.
Can I Replace The Mercedes CLS55 ABS Relay Myself?
Most folks can swap out a Mercedes CLS55 ABS relay without trouble. A screwdriver or small pair of pliers should handle the job. First, pull the battery cable to be safe. Pry the fuse box open, grab the relay by hand, and rock it free. Push the new relay in fully, snap the cover back on, and reconnect the battery cable. Start the car, check the dash for any lights, and take a short drive to make sure everything’s fixed. Some skip the DIY route and take the car to a mechanic just to avoid the hassle. Both ways work, as long as the new relay is the right part.
Why Choose AutohausAZ For Your Mercedes CLS55 ABS Relay?
Grab your Mercedes CLS55 ABS relay from AutohausAZ and you’ll spend less, plain and simple. They move fast on shipping, and if you get the wrong part, the return process doesn’t drag. The store keeps parts in stock for older Benz models, so you won’t waste weeks checking every shop in town. Trying AutohausAZ once is usually enough to make it your go-to for replacement relays.
