Mercedes CLS550 AC Expansion Valve Parts

Showing 2 out of 2 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes CLS550
Category
HVAC
Subcategory
A/C Expansion Valve
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
Packaging may vary, all units manufactured by Egelhof which is the original equipment manufacturer. 1 per car.
2007, 2008, 2009, 2010, 2011 Mercedes CLS550
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$32.99
Reg
$34.36
List
$254.00
OEM
2013, 2014, 2015, 2016, 2017, 2018 Mercedes CLS550
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$44.99
Reg
$46.86
List
$94.00

The average cost of a Mercedes CLS550 ac expansion valve is between $32.99 and $44.99.

What Are Signs That The Mercedes CLS550 AC Expansion Valve Is Failing?

Is your Mercedes CLS550 AC expansion valve acting up? It’s not always easy to spot, but there are a few tell-tale signs. You may notice the AC blows warmer air than usual, or it cycles between hot and cold with no clear reason. Sometimes there’s a faint hissing or whistling from behind the dashboard—almost like the sound is trapped under the plastic. If you see frost collecting on the lines near the valve, that’s a major clue. When the refrigerant isn’t flowing as it should, the cooling just falls flat. If you’ve checked the refrigerant and everything else seems fine, it’s often the expansion valve at fault. Strange, repetitive clicking noises from inside the dash can mean parts inside the valve are sticking or breaking down. Any one of these can point to a failing part, and the sooner it’s looked at, the less likely you’ll face bigger AC issues down the road.

How Difficult Is It To Replace A Mercedes CLS550 AC Expansion Valve?

Tackling a Mercedes CLS550 AC expansion valve replacement isn’t for the faint of heart. It’s a process that takes time, tools, and patience. Since the valve sits near the evaporator and deep inside the dash, you might find yourself removing more panels than you’d expect. Dropping the glovebox and prying off trim pieces—maybe taking out the center console—all become part of the job. Evacuating the AC system comes first, of course, and handling refrigerant isn’t something to take lightly. If even one step goes wrong, you could end up with a leak, weak cooling, or worse. People familiar with Mercedes interiors and AC work make this job look easier than it is, but for most folks, the risk of damaging sensors or wiring isn’t worth it. Unless you live for a challenge, letting a pro handle the replacement will save time and headaches.

What Causes The Mercedes CLS550 AC Expansion Valve To Fail?

Most Mercedes CLS550 AC expansion valve failures trace back to a few repeat offenders. Tiny debris and shavings can work their way through the AC system after a compressor issue or sloppy repair and then clog up the valve’s passages. Moisture is another bad actor—once it gets inside, the valve’s tiny internal parts can corrode, leading to sticky movement or even total failure. Older cars face basic wear, as seals get brittle and the valve itself just can’t keep up. On top of that, if the system hasn’t been properly vacuumed or if the dryer is overdue for replacement, it’s almost asking for trouble. Anything messing with the valve’s ability to open, close, and meter the refrigerant pushes it closer toward failure.

How Can I Diagnose A Faulty Mercedes CLS550 AC Expansion Valve?

Pinpointing a failing Mercedes CLS550 AC expansion valve calls for some detective work and the right tools. AC gauges can tell you a lot by showing what the high and low pressure sides are doing. Readings that won’t budge or numbers that seem way off from normal hints at a stuck valve. Leaky or frosty lines, or strange temperature swings in the cabin, are more clues. Mechanics often run dye through the system for leaks or use temperature sensors right at the valve to spot where things go wrong. Sometimes, a Mercedes scan tool—plugged into the car—will reveal more about the entire climate and sensor system, ruling out other causes before landing on the valve. While you can catch symptoms at home, a shop with the right gear will nail the diagnosis.

What Is The Average Cost To Replace A Mercedes CLS550 AC Expansion Valve?

Cost for a Mercedes CLS550 AC expansion valve swap runs from $600 to $1,200 at most shops, depending on where you live and whether you go to a dealer or an independent. The part itself usually isn’t the priciest component—it’s the hours spent wrestling with the dashboard that add up. Recharging the AC, testing for leaks, and buttoning everything back together are all part of the final bill. Want to stick with genuine Mercedes parts? The price goes up a little, but you get a better shot at long-term performance. If the mechanic spots more worn parts in the system, figure on a higher bill, since those might need replacing too. But after it’s done, the AC should be ice-cold again.

Why Choose AutohausAZ For Your Mercedes CLS550 AC Expansion Valve?

When you pick AutohausAZ for your Mercedes CLS550 AC expansion valve, you're not just getting a box in the mail. You’re choosing an easy path—no dealership pricing games, no time wasted. Our site is simple, and our team answers the phone when you need guidance. Parts ship fast, so you don’t lose days waiting. Need to send it back? The process is hassle-free. Drivers count on us because we keep things straightforward. We know it’s your daily ride, not just a project. If you want value and real support, we're here to back you up—every time you need something for your Mercedes.