Mercedes E350 Knock Sensor Parts

Showing 1 out of 1 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes E350
Category
Emission Control
Subcategory
Ignition Knock (Detonation) Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
1 per car.
2006, 2007, 2008, 2009, 2010, 2011 Mercedes E350
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$14.69
Reg
$15.30
List
$22.00

The average cost of a Mercedes E350 knock sensor is between $14.69 and $14.69.

What Are The Symptoms Of A Bad Mercedes E350 Knock Sensor?

When a Mercedes E350 knock sensor starts going bad, your car might act up in a few different ways. Some drivers notice knocking or pinging sounds, most often under load or when the engine’s working hard. Acceleration may feel sluggish, or you might feel a hesitation that wasn’t there before. The check engine light can pop on, and you may see your fuel mileage take a noticeable dip. Idling could get rough, and in some cases, the car might even stall. Since the knock sensor lets the engine control unit know when to adjust things like timing, its failure can leave your engine at risk for damage it normally would avoid. You might chalk up the performance loss to age or a bad tank of gas, but a faulty sensor is often the culprit.

Where Is The Mercedes E350 Knock Sensor Located?

The Mercedes E350 knock sensor sits tucked away on the engine block, usually under the intake manifold and close to the middle cylinders. Getting to it isn’t easy—several surrounding parts have to come off first just to see or reach it. The spot isn’t random; it’s placed where it can “listen” to the engine most accurately. For the exact location, check the diagram for your model year, as Mercedes tweaks designs from time to time. Once you know where to look, replacing or testing the sensor goes a lot smoother.

How Much Does It Cost To Replace A Mercedes E350 Knock Sensor?

If you need a new Mercedes E350 knock sensor, expect your repair bill to range from $400 to $800 at most shops. Out of that, the part itself usually only sets you back $80 to $180, but labor costs can add up fast. Reaching the sensor takes time and a steady hand, since the intake manifold and other engine parts have to come out first. Some E350 models use more than one knock sensor, and a good mechanic will let you know if you should replace both while everything is apart. It’s best to choose someone who knows their way around European cars, even if the hourly rate is higher, since mistakes can get expensive.

Can I Drive My Mercedes E350 With A Faulty Knock Sensor?

You might get away with a short trip, but driving long term with a bad Mercedes E350 knock sensor isn’t worth the gamble. The engine relies on this sensor for feedback, and without it, there’s a real risk of damage from uncontrolled knocking. To play it safe, your engine may use more cautious timing, which means less power and worse gas mileage. Ignore the problem, and you could end up with damaged pistons or valves—repairs nobody wants. As soon as that check engine light appears and you suspect the knock sensor, setting up a repair should land near the top of your to-do list.

What Causes A Mercedes E350 Knock Sensor To Fail?

A Mercedes E350 knock sensor can quit for a handful of reasons. Heat is the big one, since years of high temps near the engine can fry the electronics inside. An oil or coolant leak might seep in, wrecking the sensor from the inside out. Sometimes the trouble starts with rough handling during repairs, or when nearby work jostles the sensor out of position. Wiring can give out, too, especially after years on the road. Any changes to how your engine burns fuel—even a tune or mild upgrade—can make the sensor’s job harder. Regular maintenance and fixing leaks early keeps the sensor working longer.

Why Buy Your Mercedes E350 Knock Sensor From AutohausAZ?

Shopping for a Mercedes E350 knock sensor at AutohausAZ gives you a pretty straightforward experience. We stay focused on parts that fit right the first time, without the sticker shock that comes with dealer markups. Our prices are some of the best you’ll see, and you won’t have to wait long—we get your parts out the door fast because we know no one wants to let their car sit in the driveway. If you need to swap a part or something goes south with your order, our returns process is clear-cut. You’re not stuck waiting or dealing with pointless rules. We’re car folks here. We want you to repair your Benz and feel good about it. Count on good prices, quick shipping, and a team that actually helps you fix the problem. That’s how we like to do business.