Mercedes G55 Camshaft Position Sensor Parts

Showing 3 out of 3 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes G55
Category
Ignition
Subcategory
Camshaft Position/Reference Mark Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 Mercedes G55 AMG
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$38.99
Reg
$40.61
List
$220.00
OEM
2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 Mercedes G55 AMG
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$29.99
Reg
$31.24
List
$222.00
OEM
2003-2015 Mercedes G55 AMG, G550
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$4.89
Reg
$5.09
List
$1.90

Mercedes G55 camshaft position sensor typically cost between $4.89 and $38.99.

What Are The Common Symptoms Of A Bad Mercedes G55 Camshaft Position Sensor?

If your Mercedes G55 camshaft position sensor is starting to go out, you'll often notice the engine acting up. Misfires are pretty common, same with sluggish take-offs and the occasional stall that leaves you double-checking your dashboard. Most drivers spot the check engine light flashing on when this sensor goes. Sometimes that light pops on and off, just to keep things interesting. Engines might crank longer than usual before starting, or sometimes they just refuse to turn over. Idling feels rough, giving you a small vibration through the wheel, and you might be stopping for gas more than usual. Problems can build up over time, but sometimes they just show up out of the blue, pushing you to get it fixed fast before bigger issues set in.

Where Is The Mercedes G55 Camshaft Position Sensor Located?

You'll usually find the Mercedes G55 camshaft position sensor tucked into the front part of the engine, right near the cylinder head, often on the passenger side. Some engines need a cover or a bit of intake hardware pulled off first, so don't be surprised if you need to clear some space. The sensor lives right in line with the camshaft, so it gets a clear reading. If you spot the wiring harness running along the engine, you can follow it back to where the sensor sits, bolted down to the cylinder head or the front cover. Once you know what you're looking for, it stands out.

How Do You Replace A Mercedes G55 Camshaft Position Sensor?

Start with safety—disconnect the negative battery cable to keep any stray sparks away. Find the sensor first, then unplug its wiring. Usually, one bolt or a couple of small screws hold it in place. Take those out, and the sensor slides free. Press the new sensor into the opening, and tighten it back down using the same fasteners. Plug the connector back in, reconnect the battery, and you’re set. If you’ve got a scan tool, clear the engine codes to wrap things up. With a basic tool set, this job won’t take long, even if it’s your first try.

What Causes The Mercedes G55 Camshaft Position Sensor To Fail?

Sometimes sensors just age out. The Mercedes G55 camshaft position sensor sits close to the engine, dealing with heat cycles every time you drive. Insulation on wires gets brittle, or connectors start to corrode. Engine leaks, especially oil, can soak right into the sensor and knock it out of commission. If you skip regular maintenance, dirt and grime start to build up and can mess with the signal. Every now and then, a faulty part slips through the factory, but most of the time, it’s the wear and tear of daily driving.

Can A Bad Mercedes G55 Camshaft Position Sensor Cause No-Start Conditions?

Yes, it can. If the Mercedes G55 camshaft position sensor isn't sending a clear signal, the engine's computer won’t know when to spark or inject fuel. The G55 might not start at all, or you might end up cranking it for a while with no luck. Sometimes, it’s random—working fine one day, then stubborn the next. When the sensor quits altogether, the engine just gives up. As soon as you see the engine code for the cam sensor and your car won’t start, replacing it is a solid bet to get things running smooth again.

Why Choose AutohausAZ For Your Mercedes G55 Camshaft Position Sensor?

AutohausAZ keeps fixing your Mercedes simple and stress-free. Need a camshaft position sensor? You’ll find the part at a price that doesn’t leave your wallet empty. There’s no reason to pay twice as much at the dealer, especially for something you can order from your own couch. Orders ship out quick—no one wants to wait weeks while the car sits in the driveway. And if you get a part that doesn’t fit, the return process is a breeze, no headaches or hoops. Everything’s streamlined: pick the sensor, check out, and track the package. Customer service answers your questions without giving you the runaround. When you shop at AutohausAZ, you keep your G55 in great shape and get back on the road fast. No drama, no wasted time. Sounds good, right?