Mercedes R350 Knock Sensor Parts

Showing 1 out of 1 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes R350
Category
Emission Control
Subcategory
Ignition Knock (Detonation) Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
1 per car.
2006, 2007, 2008, 2009, 2010, 2011, 2012 Mercedes R350
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$14.69
Reg
$15.30
List
$22.00

Based on industry averages you can expect to pay between $14.69 and $14.69 for a Mercedes R350 knock sensor.

What Are The Typical Symptoms Of A Faulty Mercedes R350 Knock Sensor?

When the Mercedes R350 knock sensor isn’t doing its job, drivers usually notice a few common issues. The engine could feel weak, like it struggles to pick up speed, and sometimes the car just doesn’t want to accelerate the way it should. The engine warning light on the dash often pops up, and scanning with a code reader might show you something like P0325 or P0330. The computer might even put the car into a safety mode, keeping the power low to avoid engine damage. Some folks also mention a rough idle, or see they’re stopping for gas more than usual. Sometimes, you’ll hear odd noises from the engine—like knocking or pinging—that weren’t there before. These symptoms can look like other problems too, so a solid diagnosis goes a long way.

Where Is The Knock Sensor Located On The Mercedes R350?

The Mercedes R350 knock sensor isn’t front-and-center. It sits under the intake manifold, tucked between the rows of cylinders. If you look under the hood, chances are you won’t see it right away—it’s usually hidden by engine parts and hoses. Getting to it often means taking off the intake setup and a few other pieces. Sometimes you can spot its wire or connector peeking out, but for a clear look, most folks wind up removing a few covers. Knowing where it is helps when you’re chasing engine lights or strange noises.

How Should A Mercedes R350 Knock Sensor Be Diagnosed?

To figure out if the Mercedes R350 knock sensor is the culprit, you should start with a scan tool. The scan might turn up a specific code tied to the sensor. Next, check the wiring and connectors for anything odd—like loose plugs or buildup of grime. If nothing’s obvious on the outside, the next step is to test the sensor’s electrical resistance, using a simple multimeter and comparing with factory specs. Sometimes the fault is in the wiring, not the sensor, so cover all angles. When in doubt, a visit to a mechanic who knows their way around Mercedes engines can save time.

What Can Cause A Mercedes R350 Knock Sensor To Fail?

The life of a Mercedes R350 knock sensor isn’t always easy. It deals with a lot of heat, vibration, and sometimes oil or coolant leaks. Over the years, this takes a toll on both the sensor and its wires. A small crack from an old gasket, or a splash of engine fluid, can be all it takes. On rare occasions, a bump or botched repair might leave it loose or damaged. Sometimes, these sensors just wear out from age. Now and then, you’ll hear of manufacturing issues, but that’s less common. Any of these can break the knock sensor's signal, leaving the engine at risk for knock and long-term damage.

Is It Safe To Drive With A Bad Knock Sensor On A Mercedes R350?

It’s tempting to keep driving with a bad Mercedes R350 knock sensor, but it isn’t a good idea. This sensor protects your engine from pinging and knocks—those small explosions that can wreck pistons and valves if left unchecked. Without it, the computer can’t adjust the timing for safe driving. The car may force itself into limp mode to try and save the engine, but ignoring the problem can lead to costly fixes. If you suspect a bad knock sensor, it’s best to handle it right away to save yourself bigger headaches down the road.

Looking For The Best Place To Buy A Mercedes R350 Knock Sensor?

At AutohausAZ, we get how important it is to keep your Mercedes R350 healthy. Tracking down the right knock sensor shouldn’t eat up your day or your wallet. We make it simple with honest prices and parts you can count on, so you keep more cash in your pocket. Waiting on a slow shipment is the last thing anyone wants, and we push to get orders out quickly. Returns are stress-free—if the knock sensor doesn’t fit, you can send it back without a hassle. Whether you’re tackling your own repairs or trusting a shop, our team’s ready to help from start to finish. You can trust us for fair deals, fast service, and help whenever you need it, so your Mercedes R350 stays on the road and out of the shop.