Mercedes SL55 Door Handle Parts

Showing 2 out of 2 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes SL55 Door Handle
Category
Select category below to view parts.
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012 Mercedes SL55 AMG, SL550
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$133.99
Reg
$139.57
List
$118.00
2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012 Mercedes SL55 AMG, SL550
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$74.99
Reg
$78.11
List
$99.00

Mercedes SL55 door handle typically cost between $74.99 and $133.99.

Why Does My Mercedes SL55 Door Handle Not Open The Door?

The Mercedes SL55 door handle sometimes refuses to open the door, even when everything looks normal. Often, the cable that links the handle to the latch gets stretched or pops off after years of use. There could also be trouble with the latch itself or the Soft Close feature malfunctioning. Cold weather is tough on these parts. Metal and plastic contract and moving parts get sticky, especially if dirt sneaks in. First, check if the handle feels loose or if anything is blocking the mechanism. You’ll need to get behind the door panel to look for broken pieces or a disconnected cable. If things look tired or bent, a new handle or cable might be the answer. Cleaning out old grease and adding fresh lube sometimes does the trick, but badly worn parts must go.

How Do I Remove The Mercedes SL55 Door Handle?

To take out your Mercedes SL55 door handle, start by disconnecting the battery since there are sensors in the door. Grab a trim tool so you don’t damage the soft parts as you pop off the interior panel. You’ll see a plastic cover by the latch—pop that out to get to one of the bolts. Undo the bolts and wiggle the handle out slowly. Don’t yank it; wires for the sensor can still be attached. Unplug the connector if there is one. Keep the screws and clips in a small container or bag, otherwise, you’ll spend too long crawling on the garage floor searching for them later. Reinstalling the handle is just the reverse, but don’t force anything back together. Take your time to line things up or the handle won’t sit right, and that’s enough to drive anyone wild.

What Causes My Mercedes SL55 Door Handle To Stick?

When the Mercedes SL55 door handle feels sticky and doesn’t move smoothly, old grease or built-up grime is usually to blame. Dust, water, and road salt get into the seams and make the mechanism gunky or even rusty. The inside can get pretty grimy through the years—no one ever sees what’s going on behind that shiny paint. Sometimes the grease just dries out until the handle starts to catch. Cleaning helps. Take out the handle assembly if you’re up for it, break out a soft brush with a little solvent, and scrub away the old mess. Wipe it down and use fresh grease, the kind meant for locks or hinges. If that doesn’t solve it, one of the springs or levers might be broken, and you’ll need a new assembly. Cold and wet weather makes sticking worse, so keeping everything clean helps in the long run.

Why Is My Keyless Entry Not Working With The Mercedes SL55 Door Handle?

Keyless entry stops working on the Mercedes SL55 door handle for a couple of reasons. Most often, it’s a dead battery in your key fob. Swap it out first—it’s a quick fix. If nothing changes, the sensor or wiring in the handle could be faulty. Water sometimes slips inside and messes with the electronics. The antenna in the door that picks up the signal could be shot too, especially after age or moisture. Try opening both doors with keyless and see if one works but not the other—that’ll narrow down where the trouble lies. Sometimes you have to pull the door apart to inspect wires and connectors, but start simple before you dive too deep. Usually, it’s the little things.

How Do I Replace The Mercedes SL55 Door Handle Gasket?

Replacing the gasket on your Mercedes SL55 door handle seals out rain and wind noise. You’ll need to pull the handle off—it’s just a few screws, nothing too tricky if you’ve done it before. Peel away the old gasket. Give the area a good wipe to get rid of any stuck-on mess or bits of rubber. Check for scratches or flakes of paint around the spot; often it’s a good time to touch up those chips. Lay down the new gasket, press it flat until it fits just right, and put the handle back on. Bolt everything up and gently test for leaks by spraying a bit of water. If the gasket bunches up, you’ll have to redo it to keep water out for good.

Looking For The Best Deal On A Mercedes SL55 Door Handle?

At AutohausAZ, we know the details matter for your Mercedes SL55, right down to the door handle. We work to keep prices below what the dealer asks, but we don’t settle for second-rate parts. Buy from us, and you’ll get a genuine fit for your car without the usual sticker shock—no need to break the bank just to get a door handle that does the job. Shipping’s fast, right from our warehouse to your home. No one wants to wait on something simple, so we don’t drag our feet. And if the handle isn’t quite right, just send it back—returns are quick, no need to argue with anyone. Questions? We answer in plain words. That’s why folks trust us again and again, from one-time fixes to bigger projects. We try to keep your Mercedes running smoothly, so buying parts feels less like a chore and a little more like checking off a box.