Mercedes SLK32 Camshaft Position Sensor Parts

Showing 2 out of 2 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Mercedes SLK32
Category
Ignition
Subcategory
Camshaft Position/Reference Mark Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
OEM
2001, 2002, 2003, 2004 Mercedes SLK32 AMG, SLK320
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$38.99
Reg
$40.61
List
$220.00
OEM
2001, 2002, 2003, 2004 Mercedes SLK32 AMG, SLK320
Ships Today
Ships Today Information Icon
Leaves closest warehouse today if ordered before 2 PM MST.
$29.99
Reg
$31.24
List
$222.00

Mercedes SLK32 camshaft position sensor typically cost between $29.99 and $38.99.

Where Is The Mercedes SLK32 Camshaft Position Sensor Located?

You’ll find the Mercedes SLK32 camshaft position sensor on the passenger side up near the back of the engine, close to the cylinder head by the firewall. It usually sits just above the end of the timing cover, tucked underneath a few hoses or wires. Sometimes you have to move these aside for a clear shot. The sensor itself is small and shaped a bit like a bullet, with a single bolt anchoring it and a plug sticking out the end. Most people work from the top using a long extension and a Torx bit. It’s easy to mistake for the crank sensor, so checking a guide or diagram first helps. Be gentle with the wiring, since connectors get brittle after years of engine heat.

What Are The Symptoms Of A Failing Mercedes SLK32 Camshaft Position Sensor?

When the Mercedes SLK32 camshaft position sensor starts to fail, the engine can crank for a long time before it fires up. Some days it might stall out of nowhere, or you’ll feel the idle get rough when waiting at a light. Acceleration turns spotty and sluggish, sometimes with a little hesitation. Owners often notice the check engine light comes on, pointing to a cam sensor code if you scan it. In the worst case, the engine might not run at all, because it can’t line up the spark right. Swapping the sensor with another working one will usually confirm what’s wrong before you spend money on new parts.

How Do You Replace The Mercedes SLK32 Camshaft Position Sensor?

First, disconnect the battery to keep things safe. Once that’s done, find the camshaft position sensor up by the passenger side head. Unhook the wiring connector. Take out the single bolt that secures the sensor—a Torx bit is needed for this step. The sensor should pull out without much force. Clean off the area to make sure the new unit seals up well against leaks. Slide the new sensor into the spot, fit the bolt, and reconnect the plug. Reconnect your battery, start up the car, and clear any engine codes with a scan tool. The whole job goes quickly if you don’t hit any roadblocks.

Can A Faulty Mercedes SLK32 Camshaft Position Sensor Cause Power Loss?

You’ll notice power dips when the Mercedes SLK32 camshaft position sensor gives up. As the signal to the ECU gets scrambled, spark timing and fuel delivery lose sync, so the engine stumbles or lags on acceleration. Keep driving with a faulty sensor, and the car might simply not start at all. Swapping for a reliable sensor should get things running smooth and bring performance back up.

Is It Safe To Drive With A Bad Mercedes SLK32 Camshaft Position Sensor?

It’s best not to push your luck with a bad Mercedes SLK32 camshaft position sensor. At first, the car may just stutter or take longer to crank, but you could end up stranded if the sensor fails completely. The risks: stalling in traffic, rough running, or even damage to your catalytic converter as timing problems let unburned fuel sneak through. As soon as signs show up, it is wise to swap the sensor before small problems turn big.

Why Choose AutohausAZ For Your Mercedes SLK32 Camshaft Position Sensor?

When you’re trying to keep your Mercedes SLK32 healthy without emptying your wallet, it helps to have a source that keeps things simple. That’s what we aim for at AutohausAZ. Not only do you get good prices for your camshaft position sensor, but the shipping is fast too. We know waiting days on end for a package is the last thing anyone wants, so we get your part out the door quickly. Returns stay easy—no long forms or tough policies—just send it back if it doesn’t work for you. If you have a question, our team will talk you through it, no runaround. With us, you’ll get the part you need, for less, and without hassle. That’s the way we do business, and that’s why drivers keep coming back when their SLK32 needs something critical like a cam sensor. Thanks for trusting us.