Audi SQ5 Camshaft Position Sensor Parts

Showing 2 out of 2 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
Audi SQ5
Category
Ignition
Subcategory
Camshaft Position/Reference Mark Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
1 per car.
2014, 2015, 2016, 2017 Audi SQ5
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$32.99
Reg
$34.36
List
$102.36
2014, 2015, 2016, 2017 Audi SQ5
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$30.99
Reg
$32.28
List
$102.36

The average cost of a Audi SQ5 camshaft position sensor is between $30.99 and $32.99.

Where Is The Audi SQ5 Camshaft Position Sensor Located?

You’ll find the Audi SQ5 camshaft position sensor set up near the top of the engine, close to the front edge of the cylinder head. Location might shift a bit across different years or engine codes, but it’s usually either tucked into the cylinder head or held down by a small bolt on the valve cover. Take off the engine cover and it almost always comes into view. Be careful, though—a handful of sensors hide in the same neighborhood. Look for a sensor with a connector and wiring harness leading to it. Pulling the right part helps, otherwise, you could unplug the wrong thing. Always let the engine cool before you reach in to avoid a nasty burn or causing damage to plastic plugs.

What Are Symptoms Of A Faulty Camshaft Position Sensor On Audi SQ5?

A bad Audi SQ5 camshaft position sensor usually starts with a check engine light staring back from the dash. The engine may stumble or hesitate when you hit the gas. Some drivers catch rough idling, random stalling, or an engine that cranks and sputters before finally starting up. You might spot a dip in fuel economy. Sometimes, the car sticks itself in limp mode — you’ll feel sluggish acceleration or limited power. These quirks show up long before the sensor gives out completely, so catching them early spares you a lot of headaches. Plug in a scan tool if you’re not sure, or swing by a shop for a quick code check.

How Do I Replace The Camshaft Position Sensor On My Audi SQ5?

Changing the Audi SQ5 camshaft position sensor isn’t complicated if you’ve done a few basic repairs before. Pop the hood and disconnect the battery first. Pull off the engine cover; sometimes the intake tube will need to come out of the way. You’ll see the sensor mounted to the cylinder head—find the tiny bolt holding it down. Unplug the connector by squeezing the tab and tugging gently. Use the right socket to take out the bolt, then twist and wiggle the old sensor free. Drop the new camshaft position sensor in its spot, line it up, and tighten it back down. Snap the connector in, put everything you removed back where it was, and hook the battery up again. Start your Audi and check for leaks or lingering codes.

Can I Drive My Audi SQ5 With A Bad Camshaft Position Sensor?

Driving with a faulty Audi SQ5 camshaft position sensor isn’t wise. Maybe it cranks up and runs, but you risk sudden stalls, sketchy throttle, or even flat-out refusal to start one morning. Sometimes it triggers limp mode, which keeps you crawling around town and can make merging dangerous. Keeping the car on the road with this problem could send extra wear through the timing system or other engine parts. If you’re already seeing warning signs, it’s best to get the sensor swapped before a minor hassle becomes an expensive recovery at the side of the road.

What Causes Camshaft Position Sensor Failure In The Audi SQ5?

Plenty of things push a Audi SQ5 camshaft position sensor to fail. Most of the time, constant heat from the engine does it in. Over time, the sensor’s internals lose their edge. Oil leaks, dust, and crud from old gaskets show up and gum things up. Wiring harness issues or connector corrosion come next—sometimes a plug works loose or the contacts inside get dirty. Once in a while, there’s a flaw from the factory, but usually it’s just age and exposure. Routine checks for leaks and quick fixes for warning lights give your sensor the longest run possible.

Why Choose AutohausAZ For Your Audi SQ5 Camshaft Position Sensor?

Picking AutohausAZ for your Audi isn’t just about getting the exact part you need. It’s about real support when a weird engine light throws off your day. Prices here stay competitive, so you don’t have to cut corners or second guess the order. Shipping moves fast; you won’t sit around for a week hoping your box lands on time. And if something’s off, returns go quick—no endless emails or stubborn hoops to clear. There’s a team behind the scenes that cares about cars and wants to hear what’s actually wrong. Call up with questions, get straightforward answers, and move on knowing you did your SQ5 right. Next time your Audi throws a curveball, let us help you get back on the road.