BMW 3.0S Engine Oil Parts
Showing 20 out of 27 part(s) found in our catalog.
Brand
Keyword
Subcategory
Mon-Fri 8-4 MST/PST (Arizona Time)
BMW 3.0S engine oil typically cost between $10.69 and $309.94.
BMW 3.0S engine oil is a special lubricant oil for the BMW 3.0S engine, which is part of the E3 series of automobiles that were manufactured in the early 1970s. Engine oil is very important to ensure the performance and durability of the engine by minimizing friction among moving components, preventing wear and tear, and assisting in heat dissipation. It also serves to clean the engine by sweeping away debris and combustion byproducts. The proper engine oil provides a way of obtaining optimum engine operation and saves you from costly repairs due to engine damage or overheating. Regular oil change intervals are indispensable for the long-term health as well as the operation of the car.
Types of Engine Oil for BMW 3.0S
- Actually, the following are the BMW 3.0S engine oil types appropriate for a BMW 3.0S based on the given brands:
- Castrol Edge: Because of its high-performance full synthetic formula, it delivers top-level performance and protection under extreme conditions.
- Liqui Moly Leichtlauf High Tech: This oil lubricates better and is designed to reduce fuel consumption and emissions and extend the life of the engine.
- Liqui Moly Molygen: This oil, with its unique molecular friction control technology, enhances engine efficiency and provides excellent wear protection.
- Total Quartz 9000 Energy: A premium synthetic lubricant that guarantees ultimate engine cleanliness and performance, it is designed to resist extreme temperatures and have viscosity stability.
- These choices are formulated to satisfy or surpass the requirements needed for peak engine performance and health.
BMW 3.0S Oil Capacity
- 1971-1973 BMW 3.0S: About 6.9 quarts (with oil filter)
- 1974-1975 BMW 3.0S: About 6.9 quarts (with oil filter)
These values are approximate and may differ slightly depending on particular vehicle conditions or modifications. Refer to the owner's manual for accurate information.
Changing the Engine Oil in Your BMW 3.0S
- Park the vehicle on a level ground and the engine should be cool.
- Collect required materials and tools: new oil filter, correct engine oil, oil catch pan, set of wrenches, and a funnel.
- Open the hood and remove the oil filler cap to allow for air entry.
- Position the oil catch pan underneath the oil pan and loosen the drain plug using a wrench so that old oil drains out completely.
- Replace the drain plug and tighten it after the oil has fully drained.
- Find and remove the worn-out oil filter with an oil filter wrench; avoid leaving the old gasket intact.
- Install a thin layer of new oil on the rubber gasket of the new oil filter before installation.
- Hand-tighten the new oil filter in a safe location but not overly tight.
- Pour in the suggested amount of new engine oil into the engine through the oil filler cap using a funnel.
- Check the oil level with the dipstick and add more oil if necessary until the correct level is achieved.
- Replace the oil filler cap and begin the engine, letting it idle for a few minutes to circulate the new oil.
- Check for leaks around the drain plug and oil filter, and repair them if necessary.
- Responsibly dispose of the filter and used oil, adhering to local regulations.
At AutohausAZ, we strive to make it simple for your shopping experience to be as hassle-free as possible. When you require BMW 3.0S engine oil, our prices are unbeatable due to the deeply discounted auto parts that we sell. With shipping that is quick, you don't have to wait long before you receive what your car requires. And, with our simple returns procedure, you can buy with the knowledge that we're here to support you all the way. Whether it's BMW 3.0S engine oil or any other component, we've got you covered.

