BMW 760I Camshaft Position Sensor Parts

Showing 1 out of 1 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
BMW 760I
Category
Ignition
Subcategory
Camshaft Position/Reference Mark Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
2004, 2005, 2006, 2007 BMW 760i
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$4.89
Reg
$5.09
List
$3.20

BMW 760I camshaft position sensor typically cost between $4.89 and $4.89.

What Are The Signs Of A Failing BMW 760i Camshaft Position Sensor?

When the BMW 760i camshaft position sensor starts going out, you might spot a few warning signs. The car could idle rough or struggle to start. Sometimes you’ll notice it stalling when you speed up or going sluggish with less power than usual. It’s not unusual for the check engine light to jump on during this time. Fuel mileage can drop. If you check for codes, you’ll often see camshaft-related faults. Since the sensor controls timing for both ignition and fuel injection, a bad one throws everything off, making the drive frustrating. If ignored, things can get worse—potentially leaving you stranded, or even leading to bigger engine problems.

How Do You Replace a BMW 760i Camshaft Position Sensor?

Swapping out the BMW 760i camshaft position sensor isn’t too hard if you’re handy with basic tools. First step—disconnect the battery. Locate the sensor up by the cylinder head. Remove the electrical plug and take out the bolt holding the sensor in place. Pull the old one out and match the new part before pushing it in. Tighten the bolt, click the connector back, then reattach the battery. After putting everything back together, clear any fault codes if you can, and take the car out for a spin to make sure it runs right. It’s a job you can do at home, though some folks feel better letting a mechanic handle it, especially if space is tight under the hood.

What Causes the BMW 760i Camshaft Position Sensor to Fail?

Heat, old age, and leaks are the big reasons the BMW 760i camshaft position sensor calls it quits. Oil can get past old seals and mess with the sensor itself, causing it to short out. Wires or connections might corrode, especially if they’ve had oil dripping on them for a while. Sometimes the sensor just wears out from years of vibration and heat cycles. A handful of cases come down to bad luck with manufacturing defects or bumps that break the unit. Keep an eye out for leaks during oil changes or routine checks; catching these early goes a long way to keeping sensors alive longer.

Is It Safe to Drive With a Bad BMW 760i Camshaft Position Sensor?

It’s best not to drive for long with a faulty BMW 760i camshaft position sensor. The engine control unit can’t get the timing right, so you could be dealing with stalls, poor power, or even a no-start. Sometimes the car dies without warning—nobody wants that in the middle of traffic. Fuel economy tanks, and it’s possible to damage other parts if you ignore the problem. Play it safe and get the sensor fixed as soon as you notice trouble. That way, you avoid getting caught out or causing extra work for yourself down the line.

How Much Does It Cost to Replace the BMW 760i Camshaft Position Sensor?

Replacing the BMW 760i camshaft position sensor isn’t cheap, but it usually won’t break the bank. The sensor itself might be between $75 and $150. Add labor at a shop or dealership, and the bill usually lands somewhere from $250 to $450. If you do it yourself, you’ll just pay for the part, and maybe a tool or two if you don’t already have them. If there’s oil damage or you need more than one sensor, expect to pay more. Always get a full quote before work starts—surprise costs are never fun.

Why Choose AutohausAZ For Your BMW 760i Camshaft Position Sensor?

When you shop at AutohausAZ, chances are you’re looking for a fair price without any drama. That’s exactly what you get—high-quality camshaft sensors that show up fast, priced right. Our team makes sure every part is up to standard; nothing random finds its way into our catalog. Orders ship quick, so you get your fix started sooner, not days later. If things go sideways or you pick the wrong sensor by mistake, returns are hassle-free. We keep things simple, because you’d rather spend your time driving than dealing with car parts returns. Our support team answers questions quickly, and we’re always nearby when you need help. AutohausAZ is about saving you money, saving your time, and getting your BMW dialed in—so your only worry is what road to take next.