Porsche 928 Power Steering Hose Parts
Showing 3 out of 3 part(s) found in our catalog.
Brand
Keyword
Subcategory
Mon-Fri 8-4 MST/PST (Arizona Time)
The average cost of a Porsche 928 power steering hose is between $14.69 and $76.88.
The Porsche 928 power steering pump is an essential component of the car's power steering system. It is responsible for providing hydraulic pressure to assist with the turning of the wheels, making it easier to steer the car.
When the driver turns the steering wheel, the power steering pump is activated and pressurizes the power steering fluid. This pressurized fluid is then sent to the power steering gearbox or rack and pinion, which helps to turn the wheels of the car with less effort. The power steering pump is typically driven by a belt that is connected to the engine. As the engine turns, the belt rotates the power steering pump, allowing it to generate the necessary hydraulic pressure for the power steering system to function.
If the power steering pump fails or malfunctions, you will notice that the steering becomes much more difficult, requiring more effort to turn the wheels. This can be not only inconvenient but also dangerous, particularly at higher speeds or in emergency situations. It's important to maintain and service the power steering system, including the power steering pump, to ensure safe and efficient operation of the vehicle.
Replacing the Power Steering Hose on Your Porsche 928
Replacing the power steering hose on a Porsche 928 can be a bit challenging, but with the right tools and some mechanical knowledge, it's possible to do it yourself. Here are the general steps involved in replacing the power steering hose:
- Turn off the engine and let it cool down. Disconnect the negative battery cable to prevent any electrical accidents.
- Locate the power steering hose that needs to be replaced. The hose runs from the power steering pump to the steering rack or gearbox.
- Use a wrench to loosen the fitting at the end of the hose that attaches to the power steering pump. Take care not to damage the fitting or the pump.
- Follow the hose to the other end, and loosen the fitting that attaches to the steering rack or gearbox. Again, take care not to damage the fitting or the steering rack or gearbox.
- Once the fittings are loosened, carefully remove the old hose from the car, being sure not to damage any other components or hoses in the process.
- Install the new power steering hose in place of the old one, taking care to route it correctly and connect it to the appropriate fittings.
- Tighten the fittings on both ends of the hose with a wrench, being careful not to overtighten them.
- Refill the power steering fluid reservoir with the recommended type of fluid and amount.
- Start the engine and check for any leaks. If there are no leaks, test the power steering by turning the steering wheel back and forth several times.
- Once you are satisfied that the new hose is installed properly and functioning correctly, you can reconnect the negative battery cable and finish up.
