BMW E30 3-Series Camshaft Position Sensor Parts

Showing 2 out of 2 part(s) found in our catalog.

Narrow Down Your Search By...
Filter search results specific to your vehicle.
Keyword
Keyword
BMW E30
Category
Ignition
Subcategory
Camshaft Position/Reference Mark Sensor
Subcategory
Can't Find What You Need?
Mon-Fri 8-4 MST/PST (Arizona Time)
Contact Us
Sort By:
BMW X5, 328i, X3, 325i, M3, 535i, 530i, 528i, 330i, 335i & more
Mini Cooper
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$4.89
Reg
$5.09
List
$3.20
BMW 325i, 525i, 325is, 325iC, 525iT
Ships Tomorrow
Ships Tomorrow Information Icon
Leaves closest warehouse tomorrow.
$37.99
Reg
$39.57
List
$165.45

The average cost of a BMW E30 3-Series camshaft position sensor is between $4.89 and $37.99.

What Are The Symptoms Of A Failing BMW E30 3-Series Camshaft Position Sensor?

When the BMW E30 3-Series camshaft position sensor starts to fail, odd things can happen. The idle may turn rough. Acceleration feels weak or hesitant, and sometimes the car just won’t start up easily, especially if the engine is already warm. You might notice stalling at a light or while slowing to a stop. If the sensor struggles, misfires come and go. Gas mileage drops. Sometimes that check engine light pops on, usually with a code tied to the camshaft sensor. Even if you haven’t seen a warning light, it’s worth plugging in a scanner if you notice these changes. Usually you’ll want to look into this sensor once any combo of these symptoms begin to show.

How Do I Replace The BMW E30 3-Series Camshaft Position Sensor?

To swap out a BMW E30 3-Series camshaft position sensor, first disconnect the battery to stay safe. Most of the time, you'll need to move a few covers or hoses out of your way at the front of the motor. Once you find the sensor, unplug it and make note of how it's installed. Remove the old sensor, line up the new one the same way, and bolt it into place. Double check that the plug is tight and wires look good. Clear codes from the computer if needed, and start the car to test. Replacing this sensor doesn’t call for special tools but does need patience and a steady hand. Some folks prefer a shop to handle the job, but many owners try it at home with a decent set of wrenches.

Where Is The BMW E30 3-Series Camshaft Position Sensor Located?

Locating the BMW E30 3-Series camshaft position sensor isn’t hard once you know where to look. Take off the plastic engine cover, if there is one. You’ll usually spot the sensor at the front of the cylinder head, close to the cam gear. It’s a small part, usually with a single plug or a couple of wires running into it. Location can change a bit with different E30 engines, so if it doesn’t jump out right away, try a quick check in the repair manual or online for your specific model year. You won’t need to tear down the entire engine to get to this sensor.

Can I Drive With A Faulty BMW E30 3-Series Camshaft Position Sensor?

People often think they can ignore a faulty BMW E30 3-Series camshaft position sensor for a while, but it’s risky. Sure, the car might start and run, but you’re gambling with reliability. Rough runs, hard starts, and stalling can sneak up at the worst moments, which is no fun to deal with on your commute or in traffic. Over time, the engine works harder to compensate and can suffer extra wear. It’s better not to push it. Replacing the sensor when problems first show saves time and money in the long run.

What Causes BMW E30 3-Series Camshaft Position Sensor Failure?

Time and heat wear down the BMW E30 3-Series camshaft position sensor. Years of heat cycling under the hood, old wiring, and exposure to oil and dirt can all play a part. Oil leaks often cause trouble, soaking the sensor and making it malfunction. Sometimes, wiring gets brittle or cracked from vibration. Most of the time, these sensors just wear out after years of use. Regular checks and cleaning up minor leaks helps them last longer. If you find yourself swapping one out, look over the wiring at the same time.

Why Choose AutohausAZ For Your BMW E30 3-Series Camshaft Position Sensor?

When it’s time for a new BMW E30 3-Series camshaft position sensor, AutohausAZ is ready. We offer good prices on reliable parts, so keeping your classic on the road doesn’t cost more than it should. We ship fast and handle returns with no fuss, so you’re not left waiting or stuck with something that doesn’t fit. Our site is simple, and real people can help if you have questions. You get what you need—straightforward service, honest savings, no runaround. That’s why so many BMW owners trust us. We know these cars, we stock the right parts, and we take care of our customers. Order today and see the difference.